Main use of desoldering braid in motherboard repair is to accurately absorb and remove residual solder.
Its specific application scenarios include:
• When removing components: It absorbs the short-circuited or excess solder between pins to ensure the components are removed smoothly.
• When repairing solder joint faults: It eliminates old solder that is oxidized or poorly soldered, preparing for re-soldering to form flat new solder joints.
• When cleaning pads: It removes residual solder dross on the pads, restores the flatness and conductivity of the pads, and prevents poor soldering in subsequent processes.
Specifications:
Material: Copper
Width of desoldering wick: 0.8mm, 1.0mm, 1.5mm, 2.0mm, 2.5mm, 3.0mm, 3.5mm, 4.0mm
Length of desoldering wick: 1.5 meter / piece
Features:
1. With low residue design-- This solder braid helps clean spare solder on the pin away to avoid short circuit, especially great for small, hard to reach areas.
2. Pure oxygen free copper wire-- No clean flux for easy usage. The solder wick can help clean some residue flux and increase the speed of cleaning the PCB pad.
3. Braid design-- Copper wick with fine braid design to promote strong capillary action to pull in excess solder.
4. Features-- Oxidation resistivity, anti-corrosion protection and good thermal conductivity.
5. Widely use-- Can be used to correct mistakes with small boards on PCBs, remove relays and other components from printed circuit boards, re-solder mechanical keyboard switches, unsoldering old wire from devices, desoldering computer parts such as a motherboard and so on.
Notes:
1, Please allowed 1-3mm differences due to manual measurement, thank you!
2, Due to the difference between different monitors, please understand that the picture may not reflect the actual color of the item.
• The soft solder wire design enables fast heat conduction, suitable for rapid solder sucking.
• Copper Flat Pin Weave
• High surface tension minimizes thermal damage to circuit boards
How to use it?
Step 1: place the desoldering wick on the soldering point of the circuit boards to be removed. Step 2： Then use an electric soldering iron tip to lightly press and heat, the solder residue will be absorbed by the desoldering wick after melting. Step 3: Once the solder residue has been absorbed, remove both the soldering iron and the desoldering braid wick. Cut off the wick had been used, repeat this process if needed.
